ACCULOGIC, INC.

ISAPPORT

  Data bus:                  16-bit ISA

  Size:                      Half-length, full-height card

  Hard drive supported:      Up to seven Fast SCSI-2 devices

  Floppy drives supported:   Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB
                             drives

[Image]

                        CONNECTIONS

                Function                      Location

  50-pin SCSI connector - external               J1

  50-pin SCSI connector - internal               J2

  34-pin cable connector - floppy drive          J3

  4-pin power connector                          J8

  4-pin connector - drive active LED             J9

                        USER CONFIGURABLE SETTINGS

              Function                    Location           Setting

  »   Floppy drive interface                JP2             Pins 2 & 3
      enabled as primary                                      closed

      Floppy drive interface                JP2             Pins 1 & 2
      disabled                                                closed

  »   Normally configure board              SW1             Position 2
      during installation

      Lock configuration during             SW1             Position 1
      installation

      Reset configuration                   SW1             Position 3

  Note: SW1 is set to normal unless two ISApport boards are installed on
  the same system. In this

  situation, the boards are installed sequentially. First, board 1 is
  installed and configured. Then,

  its SW1 is set to lock, and board 2 is installed and configured with
  its SW1 set to normal.

  The reset setting for SW1 is not identified.